ChineseEnglish
The working principle of USB3.0 and technical specification
Publisher:Hunan Jianghan Electron Technology Co., Ltd.       Time:2015-01-16

The working principle of USB 3

USB 2 based on the half duplex two-wire bus, can only provide one-way data transmission, while the USB 3 using a dual simplex four wire differential signalline, so support bidirectional parallel data transmission, it is full duplex bus mode, which is the key of USB3.0 transmission rate soared to reason. In addition, USB 3 also introduces new power management mechanism, supportstandby, dormancy and suspended state, so the maximum can also provideabout 900 Ma of power, at the same time take intelligent setting in power supply management, can cut off the power in the standby time, not only hasthe advantage of better charge of intelligent mobile phone, also can provide notebook products better battery life.

In simple terms, the core advantage of USB3.0 technology are three: high speed, downward compatibility, provide more power supply capacity.

USB 3 technical specification details

Transmission rate

The actual transmission rate of USB3.0 ultra high speed interface is about 3.2Gbps (400MB/S). Theoretically the highest rate is 5Gbps (625MB/S).

Data transmission

The introduction of USB3.0 full duplex data transmission. The 5 line of 2 rootsare used to transmit data, the other 2 root for receiving data, and the 1 root is ground. That is to say, USB 3 can be synchronized in full read and write operations. Previous versions of USB does not support full duplex data transmission.

Power Supply

Power load has increased to 150 MA (USB 2 is around 100 mA), configuration of equipment can be improved to 900 ma. This is better than USB 2 high 80%,faster charging. In addition, USB 3 of the minimum working voltage from 4.4 volts to 4 volts down, more power.

Power management

USB 3 does not use polling, but use interrupt driven protocol. Therefore, in theinterrupt request data before transmission, standby equipment is not consumed. In short, USB 3 support standby, dormancy and suspended state.

Physical appearance

The above specification will be reflected in the physical appearance on USB 3.But the USB 3 cable will be more "thick", this is because the data line USB 3more than the 2 to 4 root internal line. However, the socket is defects in USB 3.It contains extra connection equipment.

xi�ɩVersion:0.9StartHTML:0000000128EndHTML:0000001430StartFragment:0000000164EndFragment:0000001394SourceURL:about:blankUSB 2 based on the half duplex two-wire bus, can only provide one-way data transmission, while the USB 3 using a dual simplex four wire differential signalline, so support bidirectional parallel data transmission, it is full duplex bus mode, which is the key of USB3.0 transmission rate soared to reason. In addition, USB 3 also introduces new power management mechanism, supportstandby, dormancy and suspended state, so the maximum can also provideabout 900 Ma of power, at the same time take intelligent setting in power supply management, can cut off the power in the standby time, not only hasthe advantage of better charge of intelligent mobile phone, also can provide notebook products 


上一篇:What is the technical basis of connector, connector

下一篇:USB extension line of insufficient power supply solution